AJAX wireless alarm installation for homes and businesses in Whanganui, the Manawatu and across New Zealand. Encrypted, self-checking and controlled from your phone, with a clean install and no cables through your walls.

Every AJAX system runs from a wireless control panel called the Hub. It talks to every sensor, keypad and siren on the property over its own encrypted radio.
A wireless control panel that connects to the internet and, on most models, the mobile network too.
AJAX’s own encrypted protocol. Each device checks in every 12 to 36 seconds.
Sensors, keypads and sirens placed where they are needed, with no cabling.
Arm, disarm and get alerts on your phone, for everyone in the household or team.
Mix and match devices to suit the property. They all report to the same Hub and show up in the same app.
Motion sensors that pick up an intruder, with pet immunity so the dog does not set it off.
Opening sensors that trigger the moment a door or window is opened.
Listens for the sound of breaking glass, before anyone is inside.
Smoke and heat detectors that alert your phone and sound every siren.
Leak sensors that can shut off the water supply before a small leak becomes a big one.
Arm and disarm with a code, a tag or your phone. Sirens inside and out complete the system.
AJAX systems check themselves constantly and tell you the moment anything changes.
Alarms, faults and arming changes sent straight to your phone.
Communication between devices is encrypted, with jamming detection built in.
Up to 7 years on some devices, with a warning in the app well before one runs flat.
No cables to run, so most installs are done with minimal disruption.
Link lights, sockets and water valves to what the alarm is doing.
Every device reports if it is opened or pulled off the wall.
AJAX is our go-to for homes and small businesses. For large commercial sites, or where the alarm needs to work closely with access control, a wired ICT system is often the better fit. We work on all systems, so we recommend what suits the job.
Anywhere a tidy, fast install and a good phone app matter.
Intruder, fire and leak protection in one system, run from your phone.
A system that can come with you when the tenancy ends.
Glass break and door sensors, with staff codes and tags for opening and closing.
Quick to install with no disruption to a working office.
Alerts for intruders, smoke and leaks when nobody is there.
Workshops and sheds covered without trenching or long cable runs.
A good AJAX system is more than sensors on the wall. We place each device where it works best, name every one in the app, set up each user and make sure alerts go to the right people. After that, we are your local contact for anything that needs attention.
“No problem has been too big and gone unsolved.”
AJAX uses its own encrypted radio, detects jamming attempts and checks in with every device every few seconds. If a device goes quiet or is tampered with, you know about it straight away.
Up to 7 years on some devices, depending on the device and how busy it is. The app warns you well before a battery runs out, and we can replace them as part of a service.
The Hub has a backup battery, and most models can switch to the mobile network if the internet drops, so alerts keep getting through.
MotionProtect sensors have pet immunity. We set them up to suit the size of your pets and place them where they will not be fooled.
Yes. We can connect your AJAX system to a professional monitoring centre, so someone acts on an alarm even when you miss the alert.
It depends on the size of the property and the devices you need. We visit for free and give you a clear written quote.
New system, adding devices, or taking over an AJAX system someone else installed. Tell us a bit about the property and we will be in touch, usually the same day.

Electronic security systems for homes and businesses. Based in Whanganui, working across New Zealand.
© 2026 Sectek Security Ltd. All rights reserved.
Licensed security provider and consultant · PSPLA 010462 / 2021